![]() ![]() ![]() If the device is properly included, the green LED inside the device will stay ON.The device will be removed from your network but any custom configuration parameters.After exclusion device will automatically attempt to re-include in the next 2 minutes.Press and release the S button 3 times within 2 seconds.After the factory reset device will automatically attempt to re-include in the next 2 minutes.Press and hold the S (Service) button for more than 10 seconds (the white blink on LED strip, signal that the device is reset now you can release the S button).Connect the device to the power supply.For outlets and direct-wire modules, press the button on the device.For toggle switches or dimmers, press up and release the toggle switch.For paddle switches or dimmers, press the top or bottom of the switch.GE Z-Wave Dimmers, Toggles, Outlets and Switches The LED will blink to indicate the device is reset and ready to pair with a network.Within 4 seconds, release the on/up button.Hold down the on/up button and push in the air gap switch.Lift/pull out the air gap switch at the bottom left of the rocker.Device will blink red to signify it is being reset.Hold down reset button while re-inserting battery.Press the program button on the rear of the sensor with a paperclip for 1-second and release.īoth (PIRZWAVE2-ECO) and (PIRZWAVE2.5-ECO). #RESET AEON LABS Z STICK MANUAL#Manual Inclusion/Exclusion/Reset Procedures Repeat step 2 for each device as you wish to exclude. The LED will then return to blinking fast, indicating readiness for further deviceĮxclusions.Immediately stay solid for 3 seconds to indicate successful removal from the network.) To remove a Z-Wave device from the network, simply go to the device with the Z-StickĪnd press the button on the device you wish to remove.Need to press the button on the Z-Stick again to exclude each device. Will remove Z-Wave devices from the networks they are currently paired to. Note: While in Removal-Mode, the Z-Stick is in perpetual removal/exclusion where it Hold down the button for approximately 3 seconds. To initiate Removal-Mode, unplug the Z-Stick from the USB connector.Repeat step 2 for each device as you wish to include.Įxclusion-Mode : Deleting/Removing/Excluding Z-Wave Devices from the Z-Wave Network The LED will then return to blinking slowly, indicating readiness for further device.Indicate successful inclusion of the device into the network.) Will blink fast during a network neighbor discovery and stay solid for 3 seconds to ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |